A simple 3x AAAA (Quadruple A) battery holder, for 3d printing purposes. Attaches to standard MOLLE webbing. Held in pretty secure. Modelled with 1 unit = 1mm

Push bottom (negative terminal) of battery into bottom 'cup', then apply pressure to positive terminal to click into place unter the tab notch. Remove by opposite process--pulling positive end out first, then sliding out of negative terminal 'cup'.

Size: 9.2cm (length) x 3.1cm (width) x 2.1cm (height)

Good for airsoft, paintball, milsim, or any actual real-steel use for stuff like target practice or hunting