促销! 高达 50% 折扣 仅选定的项目. 销售结束于 小时 分钟 .

F35A - 美国空军3D模型

来自 tartino
3D模型许可: 标准    升级许可证
格式
原生
Cinema 4D 12  |  Advanced Render
OBJ
FBX
DXF
Collada
3D Studio
3D 模型 产品规格
30,501 多边形
22,785 顶点
Polygonal 几何
纹理
物料
UV映射
Unknown 未包装UV
产品编号: 702724
720个产品
自2005起

有问题吗?现在和我们聊天。

24/7在线聊天
NOTE: the pilot character is not rigged -no bones-
External pylons and weapons could be removed.
Made in cinema4d R12. .fbx format is good for importing in 3dstudio max and Maya.
- F35A: Polygons 30501 Vertices 22785
- Pilot character: Polygons 5012 Vertices 5105
This model is only artistic representation of the subject matter. I made it for a flight magazine illustration. If you like the model please rate it.

The F-35A is the conventional takeoff and landing (CTOL) variant intended for the U.S. Air Force and other air forces. It is the smallest, lightest F-35 version and is the only variant equipped with an internal cannon, the GAU-22/A. This 25 mm cannon is a development of the GAU-12 carried by the USMC's AV-8B Harrier II. It is designed for increased effectiveness against ground targets compared to the 20 mm M61 Vulcan cannon carried by other USAF fighters.
The F-35A is expected to match the F-16 in maneuverability and instantaneous and sustained high-g performance, and outperform it in stealth, payload, range on internal fuel, avionics, operational effectiveness, supportability, and survivability. It is expected to match an F-16 that is carrying the usual external fuel tank in acceleration performance.It also has an internal laser designator and infrared sensors, equivalent to the Sniper XR pod carried by the F-16, but built in to reduce radar cross section.
The A variant is primarily intended to replace the USAF's F-16 Fighting Falcon. It was also to replace the A-10 Thunderbolt II starting in 2028.
The F-35A can be outfitted with either of the two main air to air refueling types, which was a consideration in the Canadian purchase, and a deciding factor in the cost for the Japanese purchase.
相关产品
此艺术家的更多产品