The project was implemented under the scheme of the heat pump 'water / water .' Also available in variants of sea and shore-based . Station autonomous , automatic , with storage tank ( hydro) and air / vacuum battery with backup power from dizelkompressornoy installation. Sealed , closed-loop circuit in the air inlet and outlet nagnetalnogo and vacuum channels are connected , eliminating the idle compressor operation . Full automation of the station provides the following devices: - Wind compressors ; - Bi-metal sensors in water supply and coolant circuits that produce switching valve dual tanks in one of two positions , depending on the temperature of the fluid flowing through the sensor ; - Hydraulic valve allows disconnection of input pump module from the air circuit when filling the tanks of both output above the level of the payment (output pump module continues to run ) . Wind compressors in case a working or idle air / vacuum ressiver if it is not charged. Sensor balancing mode inc . / Off . - Pneumatic / vakkuum - Receivers provides dizelkompressornoy start the installation by a sensor circuit pressure water supply or coolant circuit . And also serves as a battery excess energy in addition to the double refrigerant circuit or a buffer between the power source and the ADC vetrokompressorami . Turning off the signal of the second ADC pressure sensor in the system of water supply. - Throttle ADC associated mechanical traction with bimetal sensor outlet water temperature station. With a lack of wind ADC can operate in parallel with the internals in either alternating with PCO / system / Receivers .